v Installation Procedures Indoor Timer Installation ... 2 Connecting the Valves ... 2 Connectin
To Change a Watering Day Schedule (continued):Interval Schedule1. Turn the control dial to the watering days position. 2. Set the programs switch as
3. Press the next button as needed to display d E. The currently eligible days of the week will be displayed and su (Sunday) will begin flashing.4.
8. Press the next button. The next program start time number will begin flashing.9. To review or change another start time, return to step 3.10. Ret
Manual OperationsOperating Programs ManuallyNote: Watering programs (A, B and C) can be operated individually or set to run consecutively in alphabeti
Operating Zones Manually1. Return the control dial to run .2. Position the programs switch as needed to select the program with the assigned zone(s)
Season Adjust FeatureNote: Prior to using the Season Adjust feature for the first time, refer to the ECXTRA User’s Guide for additional important oper
The Toro Promise - Limited One-year WarrantyThe Toro Company and its affiliate, Toro Warranty Company, pursuant to an agreement between them, jointly
Indoor Timer InstallationIMPORTANT: The ECXTRA Indoor model is not weather resistant and must be installed in a sheltered area. 1. Select a locatio
4. Route the wire cable into the timer through the large opening in the base of the housing or through PVC conduit (if installed). Strip insulation b
Outdoor Timer Installation Preparing the Timer Cabinet1. Remove the lower housing cover by pulling outward on the handle.2. Remove two phillips s
5. Install 1/2″ (13mm) conduit for input power wires and 3/4″ (19mm) conduit for valve wires. Note: After installation, store the Quick Start guide
Connecting a Pump Start RelayNote: Connecting a master valve or pump start relay is optional and may not be required for your sprinkler system.CAUTI
4. Replace the transformer compartment cover.5. Apply power to the timer. Note: The display will begin flashing 12:00 am. Press any button to halt
ECXTRA Scheduling AdvisorTM Installation and UseMinimum PC System Requirements*Windows® 98, SE, 2000 or XP operating system, one USB Port, CD-R drive,
To Set or Change Time/Date:1. Turn the control dial to the current time/day position.2. To adjust the flashing portion of the display, press the
Comentarios a estos manuales